The reasons for the appearance of scorched bricks in the kiln are. First, when burning bricks inside, the air passing through the middle of the billet stack is not enough, the kiln worker is not careful to watch the fire, the firing zone is st...

The general producers of gangue tunnel kilns use kiln types with large cross-sections. The kiln roof of large section tunnel kiln adopts light weight refractory concrete slab ceiling structure. Refractory concrete ceiling plate is made of aluminu...

High alumina insulation brick is mainly a light refractory material composed of mullite and glass phase or corundum together. The alumina content is above 48%. Bulk density 0.4~1.35g/cm3. porosity 66%~73%, compressive strength 1~8MPa. good therma...

Mullite insulation brick is a high alumina refractory material with mullite (3Al2O3-2SiO2) as the main crystalline phase. The general alumina content is between 65% and 75%. Mineral composition in addition to mullite, which contains low alumina a...

The main performance of the industrial kiln is mainly determined by the technical and economic performance of refractory materials, which directly affects the investment cost, work performance, thermal efficiency and energy consumption cost of op...

The direct crude oil heating furnace at the oil transmission station is an important equipment for crude oil transmission to prevent condensation and reduce resistance? The daily maintenance of heating furnace is crucial? I talk about the actual ...

Product innovation Low thermal conductivity and energy-saving refractory materials Lightweighting - designing the material structure to achieve lightweighting while ensuring the necessary functionalities such as alkali resistance. Microp...

1、Mechanical damage Subjected to a combination of pressure, pull, twist, shear mechanical stress. Kiln rotation, cylinder ellipticity, lining brick and cylinder body and between the brick and brick extrusion, twisting, kiln cylinder body defo...

1、Cement rotary kiln refractory brick lining is divided into four categories according to the size of the brick seam and the degree of fine operation. The categories and brick seam size are as follows Category Ⅰ, ≤ 0.5mm. Class II, ≤ 1m...

I. Program development 1 Arrangement of furnace plan In order to meet the urgent demand for coke and coke oven gas and increase the output of coke and gas as much as possible, the arrangement of furnace program should take into account the ...

High strength wear-resistant castable is prepared by special cement, wear-resistant steel sand and chemical admixture, which has the characteristics of fast solidification, high strength and wear-resisting. It is widely used in coal mines, power ...

Construction requirements of acid-resistant refractory castables 1、The construction of acid-resistant castables should ensure that the power is not stopped and the construction is not interrupted. 2、The template for the construction of ac...